Product/Injection
We will try to be a respected company that consideration to the customer's mind.
HOME > PRODUCT > Product/Injection
- Roof side Molding
-
Roll Forming+Extrusion+Stretch Bending+ Saw cutting+Press
Located on the roof of the car, it covers the welding section of the body of the Side panel Roof panel to prevent rust of welded parts. 
- Door sash Molding
-
Roll Forming+Extrusion+Stretch Bending+ Saw cutting+Press
Mounted on the edge of the Door, it blocks rim of the internal flow of sound, dust, rain water from the outside.
Made out of SUS material, it decorates the car exterior. 
- Door outside Molding
-
Roll Forming+Extrusion(with Flocking)+Stretch Bending+Press
Remove the attached dust, foreign pollutant from the bodies in the Glass Door Glass.
It made out of SUS material which makes it more flashy exterior decoration. 
- Wind shield Molding
-
Extrusion+Angle cutting+Heat plate bonding
Mounted on the front of the Door Glass, it blocks the inflow of the outside of the dust, noise , rain water and the like. 
- Rail Guide
-
Roll Forming+Extrusion+Roll Bending+ Saw cutting+Press+Painting
Located in the side of transportation vehicles, it does the Door opening and closing of the sliding type. 
- Bar-Roof, Side L/Rh
-
Stratch Bending + Saw Cutting + Anodazing + Silver Painting + Assembly
It is installed separately to stand on the roof of the vehicle and responsible for the luxurious appearance of the car. ( Available for roof carrier installation.) 
- Door Pillar Molding
-
Roll Forming+Press+ED coationg+Painting
It guides the motion of door glass, it separated to the gloss black type by liquid coating and the matte black type by power coating. 
- Division Bar
-
Roll Forming+Press+Spot welding+ED coating+ Powder coating
Pillar to the ability to distinguish the part with the fixed portion of the vertical drive is possible Rear Glass. 
